The system is able to be demountable and reinstalled with a percentage of 100% in places similar size the original ones . the upper section or head of the partition is attached to the false ceiling with metal pins and also the lower section is attached to the floor with metal pans .
All the metal sections the door frames and the glass frames be installed on the same level and without any relief with the addition of the outside metal double corner sections which gives the flexibility of a corner opening from 10to 350 degrees.
This system gives the possibility of exchanging the places between the solid panels and the glass frames . this system gives also a high degree of send insulation in case of very careful installation and good insulation of the borders.
The panels are cut to size needed and installed to leave an edge of 8mm between them vertically and horizontally and the glass frames are made of aluminum and are exactly the same size vertically and horizontally . althea ceiling sections floor section and also the door fraines are made of aluminum and from complete integrated system and they are painted electrostatic.
The panel sizes deepened on drawings sizes.
Panels are made of MDF covered with natural wood or synthetic covers depending on the design and the borders are painted.
The panels are treated with cellar with a ﬁnal cover of lacquer made of polyurethane half brilliant. The panels are covered internally to guarantee their stability.
Their frames are made of aluminum sections electrostically painted match the color and the brightness chosen. the glass and panel accessories are installed after adjustment on the corner tail. The glass mad of two panels each of 5 mm transparent (double glass) ﬁxed with special sections.
The door are 45mm thick, hollow care flush veneered doors, with border of massive Oak Wood of a thickness of 2 cm minimum.